A-A-50766
Door(s) to be readily accessible to, and operated by, the driver. Door to have “saf-latch” type handle to prevent accidental opening.
6. Floor. The floor is to be covered with exterior plywood (BC) at least 1/2 inch thick with sealed edges. Step well, entrance area and center aisle floor to be overlayed with 3/16 ribbed rubber. Wheelhouse end underseating areas to be covered with 1/8 inch, smooth anti-skid rubber. Floor covering moulding and trim to be installed so as to provide maximum ease in cleaning.
7. Bumpers. Rear bumper to be a minimum 8 inch die-formed, 3/16 (minimum) thick, mounted to chassis frame with double A-frame bracing at each corner to resist blows from both side and rear. Front bumpers to be supplied by chassis manufacturer.
8. Mirror. An interior mirror 5“x 16” minimum shall be provided to enable driver to view the passengers. Mirror to be backed with metal and framed with rounded corners and protected edges.
9. Driver’s seat to be of high back design, bucket type equipped with retractable seat/shoulder belt.
10. Heating. A hot water heating system shall be installed with adjustable manual controls to permit outside air recirculated air, or variable mixtures as desired (to circulate through at least the main heater core), to provide and maintain comfortable temperatures to driver’s and passenger compartments, so that no objectionable flow is directed toward any passenger. Heater hoses shall be shielded from the passenger compartment and located in protected positions. Auxiliary recirculating heater(s) shall be provided if required to assure passenger comfort.
11. Air conditioning.
a. Driver’s forward area air conditioning shall be supplied by Chassis manufacturer. Capacity to be approximately 14,000 BTU/hr.
b. Passenger compartment air conditioning shall be provided by the manufacturer to assure a minimum cooling capacity of 40,000 BTU/hr total for passenger compartment and driver’s area combined. Cooling air to be ducted to passenger compartment and equipped with outlets with shut off provisions to enable individual passenger controls.
12. Wiring. All body wiring shall be color coded and routed inside the body; and all body circuits are to be protected by resetting circuit breakers Electrical controls shall be mounted above driver’s line of vision and be illuminated.
13. Chassis
a. Wheelbase to be 125 inch minimum.
b. Unless otherwise specified, engine to be compression Ignition two stroke or four-stroke cycle diesel, with not less than four cylinders.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business