MIL-B-62152A(AT)
lubrication of body, chassis, engines, and running gear, with grades of lubricants recommended
for the ambient air temperature at the delivery point; servicing of cooling system with a solution
of ethylene glycol type antifreeze and water in equal parts by volume; and servicing of
windshield washer reservoir with water and appropriate additives.
3.7 Workmanship. Defective components or parts and assemblies which have been
repaired or modified to overcome deficiencies shall not be furnished. Welded, bolted, and riveted
construction utilized shall be in accordance with the highest standards of the industry.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the
contractor is responsible for the performance of all inspection requirements as specified herein.
Except as otherwise specified in the contract, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified herein, unless
disapproved by the Government. The Government reserves the right to perform any of the
inspections set forth in the specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.2 Government verification. Quality assurance operations performed by the contractor
will be subject to Government verification at unscheduled intervals. Verification will consist of
observation of the operations to determine that practices, methods, and procedures of the
contractor's inspection are being properly applied. Failure of the contractor to promptly correct
product deficiencies discovered shall be cause for suspension of acceptance until correction has
been made or until conformance of product to specification criteria has been demonstrated.
4.3 First production vehicle inspection. The first production vehicle produced under the
contract shall be inspected by the contractor at his plant under the direction and in the presence of
Government representatives. The purpose of the inspection shall be to determine vehicle
conformity to the contract. Acceptance of the first production vehicle shall not constitute a
waiver by the Government of its rights under the provisions of the contract.
4.3.1 Radio frequency suppression verification. The vehicle manufacturer shall furnish
with the questionnaire (commercial vehicle engineering data) a description of all interference
suppression devices used to suppress the vehicle electromagnetic radiation in accordance with
SAE J551. Data shall be sufficient for visual determination that all required suppression devices
are installed on the vehicle.
36
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business